-
```
What steps will reproduce the problem?
1. XBee modules in API mode 2, with XBee.h included in arduino file
2. Implement SoftwareSerial example using XBee.h as well
3. Upload to ATtiny chip using A…
-
```
What steps will reproduce the problem?
1. XBee modules in API mode 2, with XBee.h included in arduino file
2. Implement SoftwareSerial example using XBee.h as well
3. Upload to ATtiny chip using A…
-
I noticed that in some of the circuits that have capacitors, the capacitors have an initial charge to them, But this is only when the circuit is initially loaded, not when reset is pressed. would it b…
-
If a crystal is used, this does make DDRB unusable for using it for the LEDs, as in the book? Or is there a trick to make it work?
The crystal is covering up the PB6 and PB7 pins.
Related:
https…
-
In the **RP2040 Datasheet** with build-date: _2022-06-17_ and build-version: _7028f9f-clean_ the table of contents, "4.3.14. **IC_CLK** Frequency Configuration" is described but its source is never de…
-
Some patches may be better (for me) if they sounded a bit more 'ambient'. Create a function to "Ambientize" the sounds.
Ideas
- Make sure that both of the filters are somewhat opened
- The Atta…
-
Hi.
I need help with modifying BlueSeries_12A_cod for Nfet driver IC IR 2101.
Original cod is pull up HI (inverted) for pnp transistor . I need to modify it to LO (not Inverted) to driver IC.
Or an…
-
```
What steps will reproduce the problem?
1. Turn off osc1
2. Turn up osc2
3. Hold any note
4. Adjust the osc2 cents slider
What is the expected output? What do you see instead?
The tone should adju…
-
```
What steps will reproduce the problem?
1. Turn off osc1
2. Turn up osc2
3. Hold any note
4. Adjust the osc2 cents slider
What is the expected output? What do you see instead?
The tone should adju…
-
```
What steps will reproduce the problem?
1. Turn off osc1
2. Turn up osc2
3. Hold any note
4. Adjust the osc2 cents slider
What is the expected output? What do you see instead?
The tone should adju…