-
Hi there,
As requested by William Douglas, I hereby post this issue on GitHub. I marked this issue as CRITICAL, because it keeps Clear Linux from booting.
Problem occurs when:
A) Installing Cle…
-
I appoligize in advance if this is not where i should be looking for the "support" / guidance on this
## Bug report
Hello i am getting this in the log/consol after following the guide.
is the e…
fanno updated
9 months ago
-
### The issue
Hi,
I tried both the multi and single example code in PlatformIO with a single DS18B20 sensor. The multi example worked fine, but the single example reported a temperature of 204 de…
-
So i've gotten pretty close to getting windows 10 arm to boot. But for some reason after selecting the boot device it wont no longer detect the keyboard, when the press any key to continue prompt arri…
-
### PROBLEM DESCRIPTION
Is it possible to use Tasmota on the new [SONOFF POW Elite](https://sonoff.tech/product/diy-smart-switch/pow-elite/)?
I found some Pictures [here](https://notenoughtech.com/h…
-
Hi, I made a "4 sub-state counting for each line on the encoder" update to the program using 2 state machines. Unfortunately I didnt had the hardware to test it so I am hoping someone with the right h…
-
Hi @matth-x,
Thank you very much for this beautiful OCPP library, congratulations to you and your team.
I am able to complete one charging cycle remotely as well as locally. The meter values are…
-
My DHT reported -3275.1C when the temp outside was a bit below 0C
DHT22: -3275.1C, 76.5%
Pretty sure it was not that cold outside 🤒
Regards,
Geir
-
After syncing my [fork](https://github.com/kriztioan/NightDriverStrip) with upstream, building and uploading the firmware to my `esp32-s3-devkitc-1-n16r8v`, the 107 LEDs on my strip stay blank. The de…
-
### What happened?
During an FW upload the OpenDTU did not respond anymore. Then after a powercycle it just opened up the OpenDTU AP but did not connect to the local anymore.
Then i performed t…