-
Hi there,
When browsing the onboard SD card in TFT mode the folder names are shown as 8.3 filenames (like MS-DOS and alike) : PRINTA\~1, PRINTP\~1, 47ACB\~1.MOD, etc. This doesn't happen in the Mar…
KL-XL updated
4 years ago
-
Hi there,
I am a complete newbie in 3d printers. Just got the BTT TFT35 E3 V3.0, two ESP-01S modules and BTT Writer Module from BIGTREETECH Global Store at AliExpress. The TFT35 installed and opera…
KL-XL updated
4 years ago
-
Thanks for removing the src/Marlin.(h|cpp), but more QA was necessary: the updated, probably necessary changes to work correctly, configuration files for all the printers are only in the new Configura…
-
BLTouch is not centering to the build plate on z_safe_home. The position it homes to is center of build plate + the nozzle offsets. This results in the printer head homing to the front left corner of …
-
Ajeje
-
### Bug Description
We slice the model using Cura and transfer it to SDcard and start the print.
The prints starts out just fine but after some time (It ranges from 10 minutes to several HOURS) it…
-
Hi guys.
Hope you guys can help me a little because my printer is broken right now.
### My Configurations
So I own a Ender 3 Pro with a Cheetah 1.2a silent board. For ABL I'm using a genuine…
-
### Description
Linear Advance is not producing any good lines during the K-Factor Calibration Test on my SKR 1.3 board even though printer did produce viable lines on my previous Melzi board. …
-
### Bug Description
On the Fysetc S6, settings saved with `M500` aren't restored after reset of power cycling the board.
### Workaround
Comment out `#define FLASH_EEPROM_EMULATION` in [pins_F…
-
Copied from [my comment in #15731](https://github.com/MarlinFirmware/Marlin/issues/15731#issuecomment-549143357).
### Description
Z-endstop switch is ignored while homing Z if using BLTouch prob…