-
**Description**
I've upgraded my printer with Re-Arm board using same RAMPS shield from Mega with same TMC2208 drivers installed in standalone mode (not UART). During any movement at a reasonable spe…
-
Hi,
If my board skr e3 dip v1.0 has 3 tmc2208 uart installed and 1 tmc5160 spi.. what should i do? can i use uart mode at tmc 2208 same time spi also enabled at tmc5160
-
Is it possible to adjust the stepper current dynamicaly to prevent lost steps additional to hybrid threshold?
So this would be possible tu run higher/ lower currents than normal for short times.
T…
-
### Bug Description
Enabling Dual Z causes startup current to differ, and stealthchop to be disabled.
```
Recv: X Y Z Z2 E E1
Recv: Enabled false false false false false false
Recv: Set c…
-
### Description
It seems that the StealthChop2 autotune procedure is not respected for TMC2208 (and similar) stepper driver.
According to the TMC2208 datasheet, StealthChop2 need the following p…
-
### Description
When swapping TMC2208 UART for TMC2209 UART with the exact same hardware setup and software (Marlin bugfix-2.0.x branch commit eeaef2410ac80b7bfa21fbec98abd00003ff83f8), the steps t…
-
### compile errors
> Linking .pio\build\BIGTREE_SKR_MINI\firmware.elf
> .pio\build\BIGTREE_SKR_MINI\liba72\libTMCStepper.a(SW_UART.cpp.o): In function `SoftwareSerial::read()':
> c:\Marli…
-
Hey Guys!
I need a little help! Today I replaced the old motors and the old stepper drivers too.
Now I use 2 TMC 2130 (X,Y axis) and 3 TMC2208 stepstcks (Z, Z2, E axis), and the machine is super s…
-
### Bug Description
DEFAULT_AXIS_STEPS_PER_UNIT changes are ignored
### My TWO Configurations
Mint 19.3+Cinnamon
Win 8.1
Arduino 1.8.10 on both devices
Marlin bug-fix 1.1.9 downloaded yesterda…
-
### Description
I switched from Marlin 1.1 (bugfix_1.1.x - 7cc1410070067aa056ee17a0a32d91d41cf599c9) to (bugfix_2.0.x 8e8e48f9004155897d572a099131b0b62592cee6).
Without changing HW I'm now hearing…