-
Seems that the new HP M578 has few issues that would need improvements / additional quirks:
- The replies from printer sometime take long time (due to various reasons), and I had to adjust `DevInitT…
-
### Description
Can't connect to the printer over USB - E3 Mini v1.2 with compiled Marlin (see attached config.h)
### Steps to reproduce
1. power ender 3 on
2. plug in usb cable
3. pc, bo…
-
I tried inkcut on mac, High Sierra (10.13.6). All dependencies as well as Inkcut installed fine and I run it from the command line, but for some reason the "Set up device" menu option is not there. Th…
-
I just had and odd issue and almost started a fire. Started heating up me Ender3 with a SKR-mini-E3 to PLA temperatures (200c) using the controller, plugged in my USB. I Stepped away for a minute to…
-
Is there a command to get the status of the printer (online/offline), when the paper is ending or the paper is finished?
-
Searched high and low to try to find a solution to this issue. Everything is working great with one exception - During the middle of a print, the print randomly freezes and in turn, creates a blob/zit…
-
Hello,
I was successful to use ipp-usb when I boot Linux with systemd, but not when I boot with sysVinit.
Does ipp-usb not support sysVinit?
Thank you.
-
I'm trying to use streamdeck-ui on a Raspberry Pi 4 with 4 GB of RAM running the Bullseye 64-bit version. This is a project aimed at teaching children how to interact with a Streamdeck and a printer, …
-
-
My Tinybee is not able to show temperature correctly (EXT1,EXT2,BED are usually between 0° and 5° instead of 19°/20°), while when I warm up bed at 60°, I have a real temp between 59,5° and 61 (so it's…