-
I use atmega 64 .I have a little question in this schematic photo
https://camo.githubusercontent.com/9407f77bb6316f8ea42b45d72acb6212b8baf726/68747470733a2f2f692e696d6775722e636f6d2f426b4a664957432e7…
-
Hi
I want to use your code for a stand alone atmeg328p at 8 Mhz intern with Arduino 1.8.8
I included your json files.
A can use my code on an Arduino Version 1.0.5 without problem, I can also use …
KKuKK updated
3 years ago
-
I may have spoken too soon on #8 - it stopped working in 28256 mode in my BE6502 when using `-spi n` (`y` works).
Also, the transfer time almost triples when using `-spi n`:
* `-spi n`: `Time ta…
-
Hi,
Its few years since I last used ICSP to program AVR.
I installed libusb for USBASP. I got following error:
`avrdude: error: could not find USB device with vid=0x16c0 pid=0x5dc vendor='www.f…
-
I would like to config single LED´s with the Arduino... Will it be possible? Sorry for my Bad English.
-
Hi, and thanks for creating this useful crate; especially the svd generator.
I've started working on modifying this library so it can support the atmega1280 mcu. It will obviously need a different sv…
-
I found this very interesting MIDI swiss army knife. I was looking for someting like that.
I was wondering if it could be ported to a state of the art MCU like the ESP32 with a SD card read/writer an…
-
#### What were you doing?
OctoPrint occasionally stalls the GCode stream during prints. The issue is
relatively rare, and occurs roughly every 8-10 hours of printing. I have reason
to believe thi…
-
Hey,
Thanks for this project. Very helpful as a reference as I'm learning to do this myself :)
I'm just curious, according to the [SIM7000 User Manual](https://fccid.io/2AJYU-SIM7000G/User-Manua…
simme updated
3 years ago
-
I'm not convinced it's correct, currently...
Right now, it gets the flags, clears them all, and then jumps to app if it was a reset cause that shouldn't start bootloader... but that means that whe…