-
Hi Luc.
First I would like to thank you for all the time you spend to make this happen. I saw your recent "BTT/TFT Screen" post and started to configure the two original BTT 1MB -S based WIFI modul…
-
I tried using the upload button but it seems to require an SD card board be installed. I'm using Marlin on a MKS Gen-L on my CNC build. I can enter commands and use the on screen controls. What I real…
-
Last update to platformio introduced changes to HardwareSerial.h for the LPC176x boards.
Previously UART pins were directly (wrongly) defined whereas now `define LPC_PINCFG_UART3` must be used.
Prob…
Drzet updated
3 years ago
-
Hi, i really like ESP3D, but i ask if it is possible to add support to temp/humidity sensor DHT11 or DHT22.
It would be good a button in the UI that shows real time temperature and humidity in the pr…
-
There are now many boards based on STM32F1 MPU, available on the market. SM32F1 is a very low cost 32bit solution and I believe it will gain even more popularity among makers/manufacturers eventually.…
-
Hi! I cant connect to my SSID with "HUN Wlan" network name. I selected this from the list and i typed the password also. I get always "No SSID found" error message. Why? Space char in the SSID not all…
-
This is normal and that the status information is constantly empty?
Marlin Firmware
-
Hello
I want to ask if it is possible to add this wifi module to Anet A1284-Base V1.7 Control Board Mother Board Mainboard for Anet A8.
I found a good description here http://lokspace.eu/anet-a8-w…
-
is it possible with one
Serial Wifi Adapter Modules ESP8266 ESP-12E
adapter a relay or with a 12V 24V 36V High Voltage Switch Module 3V 5V Low Control E-Switch Mosfet Arduino to switch with a GPIO v…
-
Hi, I have a board arduino mega2560 WIFI with an esp8266, on the arduino I have a board RAMPS1.6. ESP3D is working but he can't connect to the printer. I can send commands to the ESP.
No informatio…
ghost updated
4 years ago