-
### Discord username (optional)
_No response_
### Describe the bug
Shell: `zsh`
Shell start times is too slow. It takes more than 5 seconds.
At times it takes forever to load the shell, until I…
-
I wanted to reduce my fans noise, which AWCC never managed to help me with so I tried AlienFX instead.
All I managed to achieve was getting 2 BSOD (very scary), and a resulting louder fan noise.
I…
-
Version: 136
Windows 10 21H2
(I know this is an old version, but I haven't had any issue this whole time until only recently and would love to know what's wrong)
Ever since a few weeks ago, Fan C…
-
Measurements read wrong when multiple fans are being measured.
-
**Fan control curves inverted**
On my system, the curves needs to be inverted for them to function.
I edited the curves like you normaly would, with a low fan speed at low temperatures, and 100% at …
-
I have not to been able to figure out why, but using the "fanless" or "low-speed fan" profile for me the fans are pumping (on-off in 4 sec intervalls), independently of the tempereture (for temperatur…
-
I have installed dietpi and somehow made the fans work with it. eink screen still does not display anything other than few lines. I know this is old thread but if someone can help me... I tried changi…
-
**Describe the bug**
2 fans on Bond bridge started throwing errors after restarting bond bridge plugin post Bond bridge firmware upgrade. This plugin is used under HOOBS.
**Information (please com…
-
I have a grinder consisting of five 7x7 sections of Dreadful Dirt, with fans blowing all the spawns into one Masher. Normally this works just fine as long as I stick around.
Whenever I return to th…
-
http://pastebin.com/vKf5b7RG
So this was pretty interesting. I had set up a a few fans pointing at a thaumcraft crimson cultist spawner, with a few vacuums on the other side, with the intention of ma…