-
I don't have this board but it appears to have the ability to measure battery voltage based on the [schematic](https://github.com/meshtastic/Meshtastic-device/blob/master/docs/hardware/heltec-wifi-lor…
-
for an installation i need to send mp3 from sd card to a bluetoothspeaker/receiver. the code compiles so far but the programm seems to stop at one point. the console shows:
rst:0x1 (POWERON_RESET),…
-
### Description
- Type: Bug
- Related issue: n/a
- Priority: Major
---------------------------------------------------------------
## Bug
**Target**
KL25z
**Expected behavior**
spi_f…
-
Hello,
I can not run a calibration with Marlin-1.1.0 RC7 (1.0.xxx OK) and Scara kinematic
I made a `G28`
then `M360` to move Theta 0 ° position
a look back `M114` (SCARA Cal - Theta: -17.82)
a …
-
**Make your question, not a Statement, inclusive. Include all pertinent information:**
Why I am not able to write a typical Global variable from multiple tasks and Why the if loops continuously itera…
-
@cjbe @WeiDaZhang and I have been looking at the timing stability of DRTIO on Kasli (all comments apply equally to Sayma of course).
Expectation:
E1. The latency between TTLs on Kasli DRTIO slaves…
-
I just realized that there is some problem with the UART in 1.10.0 and could track it down to 1.9.10 - there it fails, where 1.9.9 works good.
I analyzed SerialUART.cpp and tried to understand it -…
-
I had a discussion recently about the tool offset and switching tool and got a feature introduced so a tool switch can be done with out moving but as for today's RCBugFix I can't get the machine to re…
-
I am interfacing my ESP32 with an external MAX98357a breakout board. I have the pins wired up correctly but when I play ab AAC file over I2S (Homer Simpson from PROGMEM)I can hear the audio, but only …
-
I want to use the APLL to generate the required 50MHz for an external Ethernet PHY using the APLL and the EMAC_CLK_OUT on GPIO16.
### Somehow the output frequency is unexpectedly divided by 5
Ac…