-
A couple of my wyze cameras (ingenic T31X / GC2053, factory firmware says `2020_WYZE_CAM_V3_@HUALAI`) have got themselves stuck in a severely overexposed state. I don't see any errors in dmesg or the …
-
Hi,
I just got a Raspberry Pi 5 and am getting an error that my hardware revision is not supported.
Here is some hardware information from `cat /proc/cpuinfo`:
```
Hardware : BCM2835
Revision…
Puetz updated
18 minutes ago
-
On another issue @mikey said:
> @stewart-ibm and I have a ppc64tiny_defconfig which boots really fast for simulators (not public) that I'd like to push upstream. It might be good to add this as part …
-
Hello,
I have a spare ATECC508A chip hooked up to a Arduino Zero.
While executing the `Example2_Sign` the output gets stuck in the middle.
```
Successful wakeUp(). I2C connections are good.
…
-
I'm working on a open-source project that targets an stm32f205(rgt6, fwiw) in an application where memory safety is paramount. I'd really love to go full-Rust instead of some hybrid C-bootstrap-plus-R…
-
Hi! It looks like I have a WIFI problem with radxa-zero3_debian_bullseye_xfce_b6.img. Unfortunately, I have only a headless option, so I can't see any logs.
I entered a Wi-Fi SSID and password in the…
-
Using the board SN5, I can upload a program, but get the following errors when we try to upload.
![Screen Shot 2022-11-11 at 3 52 38 PM](https://user-images.githubusercontent.com/5296671/201435989-…
-
A prompt request to support **`jtop`** in Nvidia Clara Agx Dev Kit. Some info is detected correctly and is showing well in **`jtop`** already but some are not (as if it can't find information as expec…
-
### What happened
When attempting to add in a ov5647 camera on mainsail, there is consistently a no-signal when adding via the mainsail UI. Tested the camera module via CLI and was able to receive p…
-
I am trying to implement a weight sensor based on a load cell and a HX711 analog-to-digital converter. HX711 uses a non-i2c compliant two wire protocol which makes it necessary to implement new driver…