-
```
What steps will reproduce the problem?
1. We are using printHTML
2. Printed only "Hello World"
3.
What is the expected output? A single page that says "Hello World" What do you
see instead? We …
-
```
What steps will reproduce the problem?
1. We are using printHTML
2. Printed only "Hello World"
3.
What is the expected output? A single page that says "Hello World" What do you
see instead? We …
-
When firing a lot of laser projectiles at nothing slows down the game massively. Missiles don't seem to be affected. But if there are around 24+ laser shots in the air it starts chugging a lot. My shi…
-
Modifying just the PFT beta with a sweep of values -0.4e-15, -0.2e-15, 0, 0.2e-15, 0.4e-15 seems to increase the laser energy away from the baseline Gaussian mode, while I believe it should remain con…
-
Reproduced while running [my draft pull request](https://github.com/Snapmaker/Snapmaker2-Controller/pull/219) so this could be caused by my changes, but I suspect it's something else.
Reproduction …
-
Using firmware 1.14.2.
A350T machine
When starting a laster job, the work origin defaults to 172.5mm (X) and 178.50mm (Y). This is the same whether selecting "Auto" or Manual" (although I believe th…
-
Seen today with @TiberiusRheaume:
When initializing a Gaussian laser profile in 2D3V simulations, the y polarization does not work. (normal direction is z, polarization in x works.)
-
**Describe the bug**
When the laser enchant procs it counts toward blocks broken with ezblocks.
**To Reproduce**
Download the laser enchant, apply to pick, and mine. It helps if you turn the radi…
ghost updated
3 years ago
-
Occassionally when running multiple jobs, or cancelling a job and starting a new one, the Auto material thickness will set the origin to the wrong location.
The correct calculated initial work orig…
-
If a material-thickness combination has no laser settings for a certain profile, VisiCut just quietly uses 20/100 as laser setting. It should warn or at least use "0/100" (do not laser). People are ra…
mgmax updated
5 years ago