-
This is a topic covered over the last few Marlin HO where we recognised that a range of "new HW support" has crawled in into the main development baseline supported by the community.
The discussion t…
-
Hi, I'm having problem where enabling the sdsupport in config.h would render my lcd panel useless, I have reprap discount 2004 and full graphic type tested with and without the sdsupport feature in th…
-
Any solution for this problem below?
after `G29` `#define Z_PROBE_END_SCRIPT` `m402` not working
``` cpp
15:29:41.580 : echo:Unknown command: "m402"
```
-
Any bump in my nozzle based z-min probe that closes the switch causes the layers of my prints to shift. Manually triggering the switch reliably reproduces the issue. Confirmed that this is an issue on…
-
I am using your library, thanks for creating.
until now:
#include
#include
#include
LiquidCrystal_I2C lcd5(0x25, 2,1,0,4,5,6,7,3,POSITIVE);
LiquidCrystal_I2C lcd6(0x26, 2,1,0,4,5,6,7,3,PO…
-
-
When I set `QUICK_HOME` it will run BUT it crashes into the stops.
If I home each axis individually the endstops work fine.
I think I had one config that worked but I can't find it.
This is a CoreXY s…
ruggb updated
2 years ago
-
OK all Anyone have any ideas on what is going on. I have been working on getting a BLtouch working for about a week now and I haven't been able to get it working yet. i finally today got it to move up…
-
at the time of submission and shortly after yhcb2004 i confirmed it compiled correctly, also confirmed working before submit.
testing was on latest bugfix today compile errors out.
to reproduce enab…
-
### Description
Uses the same board as the ender 6 however it seems that creality simply has no support for the sermoon D1, It does have a extension board with a bltouch port on it however there …