-
In BIOS parameters, would like to enable USB 3.0 powered on when PC is off, so that my Chromebook can double as a backup power supply for my USB charged cell phone.
-
Add a way to track which member has the PoE adapter so that we can figure out who to call when it goes down unexpectedly
From Lydon [in slack](https://nycmesh.slack.com/archives/C06GW3Q92TY/p170759…
-
I would really like to see power consumption in W. Maybe with the current value as a label. So instead of "Power Draw" the label would be "12W" for the total power consuption of the system.
Proble…
-
1. Don't use motor current as the only judgment of torque.
There're two situations, one is if motor torque is bigger enough than load ( a drone), motor current will get bigger along with the load l…
-
I have a 176 leds strip. Led is ws2812b and with Psieg Prismatik, I saw a power setup at the end of device configuration. I use external adapter for strip so how much mA I must set for 1 led? That set…
-
Hi there, I have a MKS-CANable v2.0 PRO which i think has slightly buggy behavior on init/reset. I'm using the candleLight firmware blob from this repo (https://github.com/makerbase-mks/CANable-MKS/t…
-
I have followed your installation guide using Raspbian-2017-03-02 on an Pi3b with LCD7C 1024x768 screen.
Both devices are powered from a single 5V 2.5amp power supply, the screen piggybacking powe…
-
### Problem description
New IKEA inspelning power monitoring smart plug pairs fine and has all the entities in Hass. However power and voltage are reported divided by factor 10.
### Solution des…
-
Only seems to happen when the watch has been left alone for a while.
OLED display appears to briefly power-up before resetting the MCU.
Reset flags usually report a brown-out.
My best guess at the mo…
-
My task was to test the s2740vc on 24 volts.
- Erased flash
- Flashed the bootloader from 68e34de6_gcc4_8_4_Ben
- Flashed the fw from 68e34de6_gcc4_8_4_Ben
Connected a 12v power supply and spun the m…