-
## Expected Behavior
install TockOS and certificates
## Actual Behavior
/OpenSK$ ./deploy.py --board=nrf52840_dongle --opensk --programmer=pyocd
info: Updating rust toolchain to nightly-2020-06-…
-
Running on the MIMRXT1060, some register access fails fatal:
Debugger: 1.10 (S)
Clock frequency: 16.0 MHz
Breakpoint 1, dap_write_reg (reg=reg@entry=5 '\005', data=data@entry=1073829888) at da…
-
Hey,
im trying to flash my nordic chip via mbed studio and pyocd. Everything worked fine until i pressed the "update all tools" button. Unfortunately I did not found any information to this error c…
-
### Description
While running the Mbed OS Greentea tests to validate adding the `EP_AGORA` target, I found that I had to manually press the RESET button during the `tests-mbed_hal-trng` test …
-
Using version 0.27 and JLink, session.open() throws the error below. The previous version was working fine for me.
`with ConnectHelper.session_with_chosen_probe() as session:`
```
Traceback (m…
-
Please feel free to use this GitHub issue for general discussion about the GCC4MBED project. If you just want to ask me or the community a general question, then this issue is the place to do it.
…
-
At least in the presence of multiple cores sharing the same set of `static`s. Problematic code:
https://github.com/rust-embedded/cortex-m-semihosting/blob/7a961f0fbe6eb1b29a7ebde4bad4b9cf5f842b31/s…
-
I am trying to debug a board with an LPC1768 processor with MBED Studio 1.4.1 but every time I try to start the debugger I get the message "Timeout waiting for gdb server to start". Yet, when I start …
-
I am trying to debug a board with an LPC1768 processor with MBED Studio 1.4.1 but every time I try to start the debugger I get the message "Timeout waiting for gdb server to start". Yet, when I start …
-
I am developing in a virtual machine passing through DAPlink running on K20DX as debugger connected to an nRF52840 on the Agora target. I am able to flash binaries to the Agora, and I am able to star…