-
```
What steps will reproduce the problem?
1. Can't add easily my custom NS-es (IPv6 and google ones) to /etc/resolv.conf
What is the expected output? What do you see instead?
I need few additional N…
-
```
What steps will reproduce the problem?
1. First attempt - tunnel6 client from http://tunnel6.4dstabi.com/. Compilation
on device asus wl500gp with Optware - result ok. Executing t6_client - i
re…
-
```
What steps will reproduce the problem?
1.set to Operation Mode->Access Point
2.IP Config - IPv6 ->IPv6 Interface: select LAN interface only WAN is available
What is the expected output? What do…
-
```
What steps will reproduce the problem?
1.set to Operation Mode->Access Point
2.IP Config - IPv6 ->IPv6 Interface: select LAN interface only WAN is available
What is the expected output? What do…
-
Trying out current development firmware (commit f6f8350) on a wr841n v9, I get spontaneous reboots. In most cases, the router reboots ~30s after enabling the network.
The router is connected to the f…
-
```
What steps will reproduce the problem?
1. Can't add easily my custom NS-es (IPv6 and google ones) to /etc/resolv.conf
What is the expected output? What do you see instead?
I need few additional N…
-
```
What steps will reproduce the problem?
1. Enable ipv6rd
What is the expected output? What do you see instead?
Working IPv6
What version of the product are you using?
RT-N12-1.9.2.7-rtn-r3497.trx…
-
When neither of the two variables in this if statement (features/cvmfs/client.pan#L317) exist the following occurs on build:
```
Buildfile: /opt/aquilon/etc/build.xml
-verify.object.profile:
delete.o…
-
```
What steps will reproduce the problem?
I normally set up the firmware of this project on my RT-N16 and use PPPoE.
What is the expected output? What do you see instead?
NAT-PMP and UPnP did not …
-
```
What steps will reproduce the problem?
1. Setup your WL500GPv2 to use 6to4 IPv6 Tunnel
2. Go to http://test-ipv6.com/
3. Notice results of two last tests (13 and 14)
What is the expected output? …