-
I am looking to use an old 360k 5.25 floppy drive with this (thing has a nice loud stepper motor) But since the controller is expecting all drives to be 80 track, the 5.25 drive will reach the (final)…
-
Hi! First of all, this is amazing, well done!
You mentioned in your blog that it's limited to about a 45° FOV in two axes. Could you mount it on a stepper motor to rotate the transducers in one or …
-
Two line change only in "vitamins/geared_stepper.scad":
```
gearbox_colour = "#FFF7EE";
-module geared_stepper(type) { //! Draw the specified geared stepper
+module geared_stepper(type, ang) {…
-
Using CircuitPython to control stepper motors is currently pretty ugly. At the moment, I use PWMOut, precalculate the frequency steps needed to provide pseudo acceleration/deceleration, compute the ti…
-
When the Z-Probe returns after a successfully probe, it returns some 0.4mm less than the original travel so repeated G30's eventually do not return high enough to untrigger the Z-Probe itself.
-
I installed the BTT SKR 1.4 Turbo and have been able to print for a while. Recently the extruder would stop mid print. X, Y and Z would keep going and heating was kept on. After stopping print extrude…
-
Hi Stuart
Great project!
How's MARLIN configured for running this?
-
First let me say I am not an expert in any of this in fact I am nearly average so when you explain something please make it as simple as possible. My goal with this post is to learn how to print WITH …
-
Hello,
When I use this, my X turns both ways but my Y and Z turn only one way and vibrates the other way.
How do I fix this?
-
I am wanting to add the analog joystick which is part of the bug-fix version you used. It is enablable in coonfiguration_adv.h but I am not sure what pins you left available if any that you could sugg…