-
My device Arduino UnoR3 CH340G
UPD: Arduino with the Mega16 controller all works.
```
C:\Users\cpp>\\VBOXSVR\VM_Share\ArduinoSketchUploader-2.4.0\ArduinoSketchUploade
r.exe -f \\VBOXSVR\VM_Share\k…
-
**Describe the bug**
Openscad 2024-08-12 crashes on opening.
latest MacOs Sequoia Beta 15.0 24A5320a (updated today)
MAC warns about signature missing, but openscad crashes also after authoriza…
-
I have 3 t-decks. Unfortunately one of them corrupted during a download, since then I have been unable to get it to take an new firmware.
I can (sometimes) get it to boot into the rom bootloader m…
-
```
make
sudo make load
```
then reboot, still can't find ttyUSB.
sudo dmesg | grep ch34x
still show the disconnect msg:
```
284.973396] ch34x 3-4.2:1.0: ch34x converter detected
[…
-
It'd be really cool to have USB OTG serial console work with Raspberry Zero 2 W. It should be possible to use the DWC2 g_serial to provide a serial console over USB OTG, without having to use UART for…
-
```
What steps will reproduce the problem?
1. Load Examples ... 04. Communcations... SerialEvent example
2. Add while (!Serial) ; after Serial.begin() in setup
3. Upload to a Leonardo board, type stu…
-
The serial port number of the USB device is not fixed each time the operating system connects to it. ttyCH343USB0 and ttyCH343USB1 frequently change
-
I'm now able to start the kernel boot process from USB, but the boot halts when trying to locate the rootfs. I have the bootargs set to `rootfs=/dev/sda`, but that doesnt seem to work. See the u-boot…
-
Please excuse my noob question, I just need to find the mistake I am making:
1) On PIR side, I connected wires to GND, TXD0, RXD0, GPIO0 and 3.3V.
2) I soldered a wire bridge to GND and GIO0, so the…
-
[machine-conf.zip](https://github.com/user-attachments/files/16533201/machine-conf.zip)
#### Briefly describe the problem you are having in a few paragraphs:
Hello, I've been attempting to install…