-
I was following along the instructions on how to Simulate bladeRF-wiphy in Modelsim on this page: https://www.nuand.com/bladeRF-wiphy-simulation but could not find wave.do anywhere.
-
Hello
I have a RTL-SDR unit and I used to run it with gqrx until I came to know about CubicSDR.
I installed the cubicSDR package from Debian Bullseye repository in my system and attempted to run it.…
-
Hi guys. I'm trying to do a GPS receiver with blade RF. I had installed GNSS-SDR, and then I wrote the configuration file. However, when I execute the file I obtain the following result:
Initializi…
-
Any time you give a `-p X` value less than 4, you get segmentation fault. Thus for RTLs with PPM ~1, you get crappy or no calibration errors:
`Calibration failed (no cells detected). Trying again.…
E3V3A updated
3 years ago
-
Hi all, I had recently installed GNU Radio 3.8 with PyBOMBS. Then, I have tried to install gr-iqbal but I have obtained the following result:
```
INFO] Prefix Python version is: 3.8.5
[INFO] PyBO…
-
1.please if i have open source App which is supported by USRP and bladeRF only ..how can i add the HackRF drivers so that it support my HackRf dongle
please just few guides if that possible
-
Hi There,
I have a new odroid advance go with the latest sd card image found here (https://wiki.odroid.com/odroid_go_advance/make_sd_card), I have installed all the dependencies, but its failing on…
-
### Steps to reproduce
1. I tested open-source baed LTE-Cell-Scanner with HackRF one (https://github.com/JiaoXianjun/LTE-Cell-Scanner)
2. I installed HackRF host and LTE-Cell-Scanner successfully
3…
-
linux; GNU C++ version 5.4.0 20160609; Boost_105800; UHD_3.11.0.git-28-gc66cb1ba
gr-osmosdr v0.1.4-75-gae686c46 (0.1.5git) gnuradio 3.7.10.1
built-in source types: file fcd rtl rtl_tcp uhd hackrf …
-
after stopping the app, it crashes with the following error details
Process: sdrpp [5314]
Path: /Applications/SDR++.app/Contents/MacOS/sdrpp
Identifier: …