-
Hi there!
i really like your weather station, but now i´m wondering is it possible to use a bmp680 instead of the bme280?
Best wishes!
-
Hello Robin, since you dealt with the bme680, and you are a physicist, I have a question which you mitgh know an answer. Did you validate the values returned by the sensor? I used your code to compare…
-
I want to confirm that I have the following devices working properly with your code:
DS3231 (RTC)
AT24C32 (EEPROM)
BME680 (TEMP/PRES/HUMI/GAS SENSOR)
Noteworthy is, that I have all I2C communi…
-
I thing something is wrong with my_user_config.h because with the latest release version I can't use WiFi Smart Config (I use it without problems on versions 5.x.x)
- [x] _Searched the problem in i…
-
The Sensor Settings logged do appear to match those explicitly set in the example code.
For example in the below the `temperature_offset` is logged as `None` but the example code sets it to `-2.2`. I…
-
Hi i tried to compile the program using provided `make.sh`. There is new version of BSEC since last time sources were updated so I changed the path in make.config (from BSEC_1.4.6.0_Generic_Release_20…
-
Use of PyCom LoPy-4 board, firmware 1.18.0.r1 with 2 I2C modules on same channel 0, pins=(P23,P22)
This problem does not occure running 3 other LoPy-4 board with previous firmware release and same mo…
teusH updated
5 years ago
-
Hello,
the current configuration of the BME280 sensor is not meant to be used for a weather / climate measurement and therefore the chip is running to warm and shows a tempertature which is 1-1.5 …
adb76 updated
5 years ago
-
In the file Adafruit_BME680.cpp, it appears that the final pressure calculation on line 338 is missing a factor of "/ 100.0".
The "/ 100.0" is correctly in the previous line 337, but it is in a co…
-
I have a 1-wire to i2c board based on i2c-bcm2708 which also requires i2c-dev to be loaded. I have managed to load i2c-bcm2708 by adding a reference to it on a CONFIG usb stick, but i2c-dev just won't…