-
Hi,
Tx a lot for your work.
I just solder my first SDBox Mini and trying to make it work. (rev2b)
I compiled the firmware from this source : https://github.com/jbilander/amiga-par-to-spi-adap…
-
Hello, I am trying to verify a code with arduino for the control of a DC motor with an ATtiny 1606 but i have this message " error "This sketch takes over TCA0, don't use for millis here. Pin mappings…
-
Output of `restic version`
--------------------------
I typically use:
```
restic 0.8.3
compiled with go1.10 on linux/amd64
```
but I also tried with:
`restic 0.9.2 compiled with go1.10.3 on l…
-
funkyluke
Sun 26 Apr 2020 08:27:30 PM UTC
Programmer hardware: avrisp2
Device type: 8535
EEP Programming works:
avrdude -p8535 -cavrisp2 -Pusb -U eeprom:w:eep.hex --> verifies OK
Flash Programming…
-
Since I couldn't get Octoprint to work because of all the timeouts / RX Buffer overflows (see #738 for some info about that) I was trying to use Octoprint while printing from SD.
But even that does…
-
Fri 30 Sep 2016 05:03:34 PM UTC
CH341A or CH341H SPI Flash/EEPROM programmer.
This code was successfully tested on Windows with libusb driver.
[file #38632: 0001-CH341A-Programmer.patch](https://sav…
-
When trying to flash an ATTiny412 directly from the CLI using a pre-generated .hex file, I receive the following error:
```
$ python3 ./prog.py -d attiny412 -wd 1 -u /dev/ttyUSB0 -a write -f ./ATT…
-
Hi
I also have a problem installing firmware 3.90 on my mk3s + mmu2s, the firmware is installed but with an error (flash failed) and only in English, then it is not possible to change the language if…
-
When trying to upload the bootloader to my Arduino Uno board, avrdude fails (see attached log).
The reason seems to be that the extended fuse byte is not read correctly, because avrdude now read th…
-
Hello everyone,
I have completed work on a new u-boot bootloader. I need someone for testing it out on different devices. The list includes:
Xiaomi Dafang -> was tested from @hyteoo, @benleb
Xia…