-
```
What steps will reproduce the problem?
1. Arduino IDE 1.03, Mega 1280 board, 305 library version, open-electronics
shield
2. Using serial hardware, with jumper connections from pins 18-19 of Ardu…
-
```
If take standart sample GSM_GPRS_Library_Client (working well) and slightly
increase memory used,then the sample stop to work. For example if change string
N 19 "char msg[50]" to "char msg[100]"…
-
```
What steps will reproduce the problem?
i want to control led throught sms when i send sms pompeon led should turn on
and when i send sms pompeoff led should turn off and when led turn off PIR
se…
-
```
What steps will reproduce the problem?
1. I downloaded and setup this library
2. run my attach file
What is the expected output? What do you see instead?
I expect to receive sms 5 times. but i re…
-
```
I would like to ask if it is possible to relocate the connections in D10, D11,
D12, D13 to other pins? I am using the GSM/GPRS shield, and I want to integrate
a microSD storage for my data. Howe…
-
```
What steps will reproduce the problem?
1. Problem with the function CallStatus
What is the expected output? What do you see instead?
When i call the function it didn't see the incoming call and …
-
```
Hi,
I try to get the GSM-Shield run with Leonardo and Go-Between Shield with mapped
pin 4/5 to Leonardo Pin 0/1 to use Serial1 instead of SoftSerial.
Define MEGA does not help, and my skills ar…
-
```
I'm using Arduino Mega 2560 with IComSat GSM shield.
I've already trim the pins 1 and 2 of the shield(the ones below arduino's pin 1
and 0) so I must use these ones :p
The codes of the library on…
-
```
when i connect pir sensor with gsm shield, gsm shield turn on for few seconds
then turn off i also have used adaptor 12v 1amp but still same
problem..............?
```
Original issue reported o…
-
```
What steps will reproduce the problem?
1.
2.
3.
What is the expected output?
GSM Shield testing.
DB:NO RESP
DB:ELSE
DB:ELSE
DB:CORRECT BR
GPS module has to become power on by GSM_ON pin if NO R…