-
**Describe the bug**
I've got 2 printers on marlin running by octoprint. Both printers have this issue.
Settings Octoprint, see picture. One of the printers is set to the 'new' settings, the other…
-
The `charge_energy_added` sensor gets reset to `0` each time a new charging session starts, and I observed in my energy dashboard that this was recorded as a huge negative. I found commit https://gith…
-
From @Yoooi0 on discord:
> you probably thought about this before but I'll repeat my suggestion for v4 i posted here some time ago, i think all actuators should be collapsed to one Actuators list i…
-
Not sure what is causing this at the moment, I've had a file stop mid print twice now, but it stopped in two different areas it appears. I've also managed to get through this print 1 time in between t…
-
Is it possible to use 2 stage heating where the second heater kicks in without the primary turning off ? I have both radiators (without smart valves) that uses an average termerature across rooms and …
-
### The problem
My Tuya smartplugs are no longer reporting energy consumption entities in Home Assistant. That is: Current, Voltage and Power. It worked fine before the new Tuya sign in changes. It …
-
### The problem
loaded the intergration and signed in. I just dont see the heaters
### What version of Home Assistant Core has the issue?
2024.1.0
### What was the last working version of Home As…
-
### The problem
I have four adax heaters and for a few days now, I can barely control them from the interface, and the automations don't work at all. The error log says so: WARNING (MainThread) [adax…
-
Correct me if im wrong only the Pro has to bed heaters, so shouldn't the printer.cfg for the other three models ###comment out [gcode_macro PID_Tune_Inner_BED] and [gcode_macro PID_Tune_Outer_BED], an…
-
### Feedback
This also works with the HPS10-50, HPS10-80, HPV10-50, HPV10-80 models of the AO Smith water heaters
### URL
https://www.home-assistant.io/integrations/aosmith
### Version
_No respon…