-
Hi Everyone,
I am using an electron with a SX1276 lora module to act as a receiver and I'm having a strange issue.
When I connect up the LoRa module to a Arduino mini, I get good range (100m in …
-
Hi,
It looks the Sync Word doesn't work correctly.
Please advice.
I am trying to make 2 privet LoRa network and separate them with Sync Word but both receiver receiving both senders message.
Tha…
-
We need at least 2 of them. We can duct-tape them on NUCLEO boards.
-
Hi,
we are setting up a lora gateway and we followed the same steps mentioned in https://github.com/ttn-zh/ic880a-gateway. but we are unable to find complete procedure to run the gateway connected to…
-
* [Data sheet](http://docs.rakwireless.com/en/RAK831%20LoRa%20Gateway/Software%20Development/RAK831%20Datasheet%20V1.2.pdf)
* [Semtech Data sheet](http://www.semtech.com/images/datasheet/sx1272.pdf)
…
-
I tried the code on my Nexus with my Lorank8 Gateway and connected it to TTN network.
In TTN device window i see the Test = 0x00 data in the uplink payload. Sending a downlink byte 0x01 via TTN device…
-
Hi,
I am sending 1 LoRa packet (1,2, or 3 bytes long) every second at 915 MHz (125 kHz bw) from a SX1272 LoRa end-node using the program https://os.mbed.com/users/dudmuck/code/sx127x_simple_TX_shield…
-
In LoRaMac.c, OnRadioRxDone, the ACK bit is checked:
``` // This must be done before parsing the payload and the MAC commands.
// We need to reset the MacComman…
-
Your project arduino-LoRa is pretty interesting, the example of the sender an receiver are pretty well simplified :)
I have some questions :
I don't relay know what type of Arduino card I shoul…
-
First of all congratulatons.
I have a LoRa (SPI device) based transmitter and receiver, writen originally for Arduino Pro Mini, and it works just fine on the Arduino Microbit.
I2C stuff works …