-
MidiSynth example the problem of repeatedly "pressing" a key when it is released.
Notes are sounded twice with one press. My keyboard is not sensitive to key pressure. What's with that
make? Build …
-
New AVR MCUs contain a list containing all interrupts, similar to the following (`attiny412.atdf`):
```
…
-
To reproduce:
- Get a non-arduino-preloaded Atmega168
- Flash any sketch using programmer (e.g., Blink)
- Sketch does not work (for Blink: LED just stays on all the time)
For comparison:
- Flash the …
-
Hi, I am using an arduino Pro mini Atmega168 3.3V, 8Mhz. ALso, the Mini USB Host Shield.
If I flash the USB_Midi_coverter code, all works and I have a signal on the Arduino TX pin when I send a midi …
-
Hello,
It's a very nice library for Arduino.
But for my project I need to connect multiple Arduino's and a Raspberry Pi. Is it possible to port/convert or wrap the library for using it on Raspberry …
-
Open Charge Point Protocol: http://www.openchargealliance.org/protocols/ocpp/ocpp-16/
Allow OpenEVSE to integrate easily with other charging networks.
Spec attached:
[ocpp-1.6_edition_2.pdf](…
-
I'm seeing periodic oscillations and occasional low readings on Rearm, but only once I start a print.
running the heaters and jogging the y axis also reproduces the issue, but not as bad.
i've recal…
kfazz updated
3 years ago
-
Hi,
Since PLA is basically for kids (for toys etc.) it would be nice if the Wizard etc. asked to what temps (or what filament your using) to preheat the hot end.
-
### Bug Description
My LCD screen flickers in weird chinese/ASCII characters
https://www.youtube.com/watch?v=eOpBX6If8AI
(the display is switching through several "sites" full of weird characters…
-
Hi Alexey, I have not yet used any Nokia5110 display and I would like to test it with your fabulous library. In fact I may upgrade some projects from ssd1306 to pcd8544.
I was looking to your demo ex…