-
Tower C runs only when I send the command G29. It is not possible for delta printer!
How can I fix it?
-
Please pull up:
http://3dprintboard.com/showthread.php?20871-Question-about-AUTO_BED_LEVELING_GRID_POINTS&p=83412#post83412
I'm wondering if we should relax this check a little bit:
```
#if X_PRO…
-
I use bed auto leveling in my Cartesian printer since the previous version of marlin and worked just fine.
But now sometimes when I give the G28 command at the time that the Z axis is lowering to se…
-
This one is more of a request for clarification than an issue, so hope it is tolerable to post it here.
I own prusa i3, rework 1.5 diy version by emotiontech. It has direct extruder and inductive pro…
-
when i input param
```
#define X_PROBE_OFFSET_FROM_EXTRUDER 10 // Probe on: -left +right
#define Y_PROBE_OFFSET_FROM_EXTRUDER 24 // Probe on: -front +behind
#define Z_PROBE_OFFSET_FROM_EXTRUDE…
lcfm1 updated
2 years ago
-
Don't understand how to get rid of the compiler warning:
`sketch\planner.cpp:560:25: warning: unused variable 'z_fade_factor' [-Wunused-variable]
constexpr float z_fade_factor = 1.0;
```
In …
-
Marlin Development downloaded 22/03/15, Core XY, Arduino 1.05
Trying to check Thinkyhead's #1553 sanity checks but getting a compile error.
Invalid conversion from 'int' to 'PROBEACTION' line 2439 i…
-
I have problems with the Auto Bed Leveling .
ABL is always working fine by the first print , when I start the printer the first time ( perhaps next day) the first Z layer is always perfect with Z-0.…
-
I have been struggling with consistent layer shifts (not always at the same layer) printing thorugh Octoprint on my Prusa MK3S. Layer shifts are on the order of 0.2 to 0.5mm can would typically happe…
-
when the PINDA Probe is defective or has a broken wire the XYZ Calbration on the MK3 starts to search for the calibration points at Z 210.
see here: https://www.youtube.com/edit?o=U&video_id=X5-wj…