-
I was trying to adjust my fan curve on my 2022 G14 and realized that the default curve that GHelper shows for each profile, does not match what the default bios curve is actually doing.
If you se…
-
I have a 2020 G14 with RTX2060. When I try to click on Eco mode software waits for about a second while showing text "Changing ..." above the button and then switches mode back to standard. I've check…
-
**Is your feature request related to a problem? Please describe.**
I've been having problems with my G14 (GA402RJ: 6900HS, 6700S, upgraded to 24GB RAM and AX210 WiFi) not going into modern standby wh…
-
**Device:** 2022 Zephyrus G14 (AMD Ryzen 9 / 6700S)
## Issue:
After uninstalling Armory Crate, whenever the device goes into sleep mode the keyboard backlight defaults to a pulsing pattern (2 fl…
-
**Is your feature request related to a problem? Please describe.**
When I use G-helper to control the ROG FlowX13, I found that I can unlock the CPU power consumption to over 75W using the CPU power …
-
MacOS 13.3.1 (22E261)
NVIM v0.9.0
Pulled latest `v2.0` from last working commit `effec96b538319c6091194f59407d6d6b265dda0` today, encountering issue:
```
Error detected while processing /Users…
-
**Describe the bug**
v0.51 makes impossible to put the fan OFF in fan profiles (either CPU or GPU), when I drag a circle down, it drags until 2000RPM, not OFF, in version 0.50 I can do that.
If yo…
-
Hi,
Before I start with my issue, I want to say thank you for creating this application- it's very helpful and a lot less bulky than Armory Crate, so thank you for your hard work so far on this.
…
-
I'm trying to get my fp sensor to work on my G14, but I'm stuck:
When trying to patch the firmware, the otp is invalid with the read_otp() value of```b''```
According to some, it does not matter, so…
-
They were there when i was using armoury crate.
I see temp in g-helper just fine too.
And those options for gpu2... which i assume is the igpu? its 0% when using in a game.
I assume power is …