-
using e957460134d984 which is tagged v1.0 _and_ 1.1, on amd64 linux:
The software consistently failed to communicate with my labrador when it was plugged into one port, though in the UI the only in…
-
Maybe you can help me - my Centos on C2 is not booting.
## What I did
### Step 1: Download the CentOS 7 AArch64 userland tar archive
Downloaded `CentOS-7-aarch64-rootfs-7.3.1611.tar.xz`
##…
-
````
[parker@inspiron15 uhubctl]$ sudo ./uhubctl
Current status for hub 1-3 [05e3:0610 GenesysLogic USB2.0 Hub, USB 2.00, 4 ports]
Port 1: 0100 power
Port 2: 0000 off
Port 3: 0303 power low…
-
Hi,
So i know mine isn't in the supported list but i gave it a try, and that's weird because when i plug the hub to my Macbookpro (with nothing attached to it) and run `uhubctl` i got what i expect…
-
as far as i know , mpu6000 accelerometer is affected by drift.
i had a nasty crash yesterday , when during rapid ascend i hit a branch and quad started to spin and lost control. all i could do is to…
-
Are there some settings that can be used to mimic the behavior of scaling an image with GDI+?
I have tried using the below settings but high resolution images still produce thumbnails that differ f…
-
I have problems with the use of Advance_L and round objekts, perhaps of the small segments.
I am using a CoreXY (Sparkcube) with Repetier Firmware 1.0.3, a direct drive extruder and an e3dv6-Hotend…
-
Love that it seem to be able to control some USB3 hubs now and I understand that I will see one USB2 and one USB3 device for each. However for me I see two USB3 and two USB2 ports of each. I guess thi…
-
Is it supprted http://plugable.com/products/usb3-hub7bc/ ?
-
sadly after connecting to 'FREE Highspeed WiFi' my phone did not open loading/welcome page android 7.0