-
I enjoy this project because it allows me to easily drive my 3D printer on my home server (which is not a dedicated raspberry pi).
However, the Klipper documentation makes clear that this setup has…
-
Dear VoronDesign
I have a quite specific setup whereas OctoPrint and Klipper run on a virtual machine that is always powered. The MCU, webcam and the V0 display are all connected to the server and …
-
A product using MKS Robin nano-S V1.3 is coming out.
For example, FlyingBear Ghost 5, Sapphire Plus, Kingroon KP3S etc.
For this board, MCU is using SMT32F407VET6D.
I made it with the MKS Robin…
-
I am having a problem with a print failing with "Heater extruder not heating at expected rate" at the same point in the print. I have done a PID calibration with no luck. Checked that the part cooli…
-
Using an ADXL345 on a Raspberry Pi Pico via USB worked up until (and including) commit e03e0e9dac5694b35b81726bd2ed18f1a67b0a26
This combination fails specifically on commit 8cfaed441d1ec295c8c4be8e0…
-
This gcode file just printed fine, I've run it again and in the middle of the print it stopped. Then I hit restart firmware and only after that I realized that I should save the log.
Log included.
P…
-
hi
thank you for creating klipper to the world
I am facing a issue ,i am making a printer that has three tools
Tools.1
It has two nozzle setup called dual extrution
Tool.2
It has lasser to…
-
Since doing an update this came up. I reflashed the MCU with no improvements.
Whats the cause?
mcu 'rpi': Unknown command: adxl345_status
This type of error is frequently caused by running a…
-
my printer is not connecting to klipper.
in ssh it shows I device but in a fluid it no…
-
When trying to perform a homing action the Z axis moves 10mm then throws a Timer too close error
Klipper is running on a Raspberry Pi 3B
Unfortunately unable to use printer due to this issue, tr…