-
It seems like my xstation has decided to just stop working.
It was working fine until now.
I reflowed the QSB three times and still get nothing on the xstation anymore. Black screen on power…
-
Hi,
Did someone manage to connect/pair with the APsystem YC600 micro omvormer.
They should connect with zigbee but it is not pairing at all.
Any sugestions are welcom.
Kind regards,
Peter
-
### Low level pin linkage
I am using a Portenta H7 Lite mounted on a PCB to control some experiment apparatuses.
**Issue:** Whenever I set the pin mode of any of these pins A5, D8, D9 as OUTPUT, t…
-
- [x] Upload testdata (@pgaskin)
- [x] Extract resources (@pgaskin)
- [x] Find libnickel offsets where necessary (@pgaskin)
- [x] Find Clara 2E stuff (@pgaskin, @NiLuJe)
- [x] Add Clara 2E to Kobo…
-
I'm using pdf_pcb_print to generate manual assembly diagrams. I would like to generate a single PDF with both front and backside, rendered as separate pages. So far, so good.
What I can't do curren…
-
My board does have an onboard blue led at pin 2.
I had to add rst (pin 16) to the display call to get it to work.
Nice app overall.
K
-
this is question rather than a issue.
anyone know where to find the pcb used to mount the mcu in the wiring diagram in the readme?
-
Today I received this board, and flashed latest 3.28 firmware. Unfortunately, it doesn't seem to boot (or at least the display shows nothing at all). I opened the board and to my surprise it has an AT…
-
Hi. Brother. Can you share your wiring diagram? Do you have contact information?
-
after digesting the articles, there continues to be a problem with the wiring diagrams/oictures
If there was another way to post this, I would, but here it is:
I have a MegaPro.
MB- TriG 0.0.2
…