-
```
Similar to the External LED enhancement request, a piezo buzzer connected to
APM board will sound:
Constant beep until Accel/Telem/Gyro has initialized
Momentary long beeps until GPS location is…
-
The file name is
LilyGO-TTGO-LoRa32-ESP32-T3-V1.6.1.txt (see .........V1.6.1.txt)
but inside I read V1.1.6
/*
Project Name:
Hardware: LilyGO TTGO LoRa32 ESP32 T3 V1.1.6,
…
Ranoc updated
2 years ago
-
This change would go onto Rev C of ELED01. Change circuit so that LED1 and 2 are in parallel, and these to LEDs are in series with R1. Repeat this for all eight strings.
NOTE: Also thinking about ch…
-
### Is your feature request related to a problem? Please describe.
To keep the compact form factor it would be great to power the ESP from the host radio through the Kenwood connector.
@spm81 test…
-
Hi using the instructions provided I have tried to build this repo for a different pinout on my rp-pico but it refused to build despite starting fresh multiple times, this is on a WSL2 instance of Ubu…
-
Hello, i ordered this with my skr mini e3 v3 but not used. It is possible to use it in another project with raspberry pi 4?
How can I connect it? I can not find if pinout for this board to be used. P…
-
### All
- [ ] Add tabs on the solar cell pads for easier soldering
- [ ] Change pinouts
### Solar Panel X
- [ ] Add reverse blocking diode
### Solar Panel Y
### Solar Panel Z
- [x] Move s…
-
Need the pinout and step file for the latest revision, please update the docs.
Also design would be easier if the design files for the MiniPCIe -> PCIe board were released too, as the board doesn't…
-
Hello,
I have a light switch with a BK7231N chip. When I run the Python programming tool, I get an error Cannot Get Bus.
The chip is directly soldered onto the board, and the board itself has a…
-
hi every one
I have a problem: after trying to use Serial.begin(300) for board CH32v003j4m6, my COM port 5 always shows an error: ''Port monitor error: command 'open' failed: Serial port busy. Could …