-
BLTouch is not centering to the build plate on z_safe_home. The position it homes to is center of build plate + the nozzle offsets. This results in the printer head homing to the front left corner of …
-
### Bug Description
I got a problem with Anet a8 plus, My capacitieve sensor goes outside my bed to measure, when I try to auto level.
I use marlin 2.0 and search everywhere for the solution. …
-
I just assembled eleksmaker a3 laser and would like to change it's mana controll board which runs grpl on arduino to grbl_esp32 (grbl upload over wifi, faster mcu, ...)
I tried to look up the docum…
-
### Description
with tmc2208 on skr1.3 im having a lot of zebra stipes, using cartesian kinematics. A friend has that problem too on cartesian, and doesnt have it on coreXY, with exact same setti…
-
I have configured Marlin 2.0 bugfix for a SKR v1.4 Turbo with TMC 2208 v3.0 drivers. I am running in the parts of a cr-10s 500. I have had success running both z motors with the single tmc stepper an…
-
Is it possible to use HW 1 uart and switch driver chips using addressing individual pins
![default](https://user-images.githubusercontent.com/20542738/52176238-f9d1ef80-27c0-11e9-9e4d-e838ec11dde0.pn…
-
trying to get 256 steps and all that jazz. Can't seem to find pin arrangement from y split to board.
-
I've 5 TMC2208 for all motors on ramps 1.5. E0 and E1 is 0.9a(was 0.7a) and rest axis is 0.7-0.8a.
The TMC2208 works when I using single extruder, but since I change to dual extruders.
E0 or E…
-
вот пример
https://www.youtube.com/watch?v=sSO3Xd0a0Z8
но были какие-то проблемы с ними на экструдере и/или с включенным linearadvance
-
Hello,
I have a problem with my board. I want to operate the board with UART, have installed on X Y Z (Dual Z) TMC2208 driver. As soon as I enter the command M122 in S3d, I get the following feedba…