-
### What happened?
I just finished my move from deconz to z2m (on Pi4, Lastest PiOS lite x64, Sonoff USB Dongle Plus with lastest firmware Z-Stack_3.x.0_coordinator_20240710,
Zigbee2MQTT-Version
…
-
### The problem
I use the AlarmDecoder integration. I've noticed that after some time passes (hours or days), it stops updating its entities.
### What version of Home Assistant Core has the issue?
…
-
I have double and triple checked the soldering and looked at it under the scope but all looks good. After getting it all done I connected it via USB and I heard the Windows USB detection sound. That i…
rwcts updated
3 years ago
-
I built the code and flashed the rom to the V2DIP1-32.
The device is recognized as USB 2.0 FD, but the USB stick connected to the device won't show up. I tested Linux 64 bit, Windows 7 32bit and Wind…
-
I’ve tried to hold down boot press reset and let go of boot but no change when I loom at lsusb
how to get into boot mode. Is the board defective?
aee74 updated
1 month ago
-
```
Hello,
I have used a external hd with usb 2.0 normally in my NAS NS-K330 (ntfs
partition).
But, i have use a new hd case with usb 3.0 (very faster), the transmission bit
start normally and soo…
-
@beaumanvienna , JC, at some point I want to see if we can implement similar hotplugging like the PS3 bluetooth controller. Should be easy enough to scan /proc for ps3/x360 usb devices and restart res…
-
Attempting to use 2 Huawei dongles (1 x E176 & 1 x E1550) concurrently has resulted in the following strange behaviours:
Note: E173 is on interface 2 and E1550 on interface 1
1) USB device for inter…
it46 updated
10 years ago
-
```
Hello,
I have used a external hd with usb 2.0 normally in my NAS NS-K330 (ntfs
partition).
But, i have use a new hd case with usb 3.0 (very faster), the transmission bit
start normally and soo…
-
### Operating System
Windows 11
### IDE version
2.3.2
### Board
ItsyBitsy NRF52840 Express
### BSP version
1.6.1
### Sketch
Custom NRF52840 board: https://github.com/amowry/WARBL2
### What h…