-
Docs state that
You can use one of the Lora32 boards without changes:
Heltec WiFi LoRa 32 V1 (433MHz SX1278)
Heltec WiFi LoRa 32 V2 (433MHz SX1278)
TTGO LoRa32 V1 (433MHz SX1278)
…
-
**Describtion**
I am using an C1101 with a couple of GS-WDS07 433Mhz door sensors. The sensors are about 5m from the receiver. I used to have reception issues on some days (every 5th to 10th message …
-
It's a newbie question!
We'll need to use up to 10 to 20 soil moisture sensor of the same type for a big greenhouse(Rainpoint).
Is it possible for a single receiver to distinguish each of them thr…
-
### Describe the bug.
Cannot transmit to 433 Mhz in Ireland using Sub-Ghz app.
Attempting to TX to 433.9Mhz
433-434 is permitted in EU (Ireland)
Flipper incorrectly says frequency is blocked for o…
-
### PROBLEM DESCRIPTION
Sonoff devices with Tasmota firmware refuse to reconnect after power cycling them. As evident by serial output the devices just says "fails to connect to AP".
The only re…
-
**Is your feature request related to a problem? Please describe.**
Ordered a v2 since I knew it was supported out-of-the-box, but received a v3..
I've tried flashing the board using the web tool, bu…
-
Current behaviour:
Panel in All lights mode. No lights on. Changing Kelvin turns all lights on even those that does not exist.
Expected behaviour:
Only lights that are already on should receive t…
-
I've done this step:
> Install [wm-esp32_test.yaml](https://github.com/zibous/ha-watermeter/blob/master/esphome/wm-esp32_test.yaml) To find the watermeterId you can set the watermeterId to 0 and t…
-
Hallo,
bekomme SignalDuino nicht auf dem Wemos D1 mini zum laufen.
Benutze die vorkompillierte SIGNALDuino_ESP8266cc1101_3.5.0.hex.
Bin nach dieser Verkabelung vorgegangen: https://raw.githu…
-
Is it possible to have a version for the TTGO T-Beam V1.1 in 433MHz ?
https://github.com/Xinyuan-LilyGO/LilyGo-LoRa-Series/tree/master/firmware