-
### Problem
I have the following alarm that’s working:
```
alarm: vault_sealed
on: statsd_vault.core.unsealed.vault-cluster-abcde123_gauge
lookup: average -5s
units: %
every:…
-
**What happened?**
Installed the kube-prometheus stack on my system, but seemed to have problem accessing the different endpoints in the system. Not quite sure what the reason is. The stack was …
-
While we can use a regex now, it may often be easier to silence alerts from an entire site using an expression like this in alertmanager:
```
site="lga0t"
```
-
I 'm trying to configure blackbox to work with our custom CA . I see issue in the logs .
```
alertmanager | ts=2022-08-17T17:41:34.355Z caller=notify.go:732 level=warn component=dispatcher r…
-
Looks like jiralert returns HTTP 500 when it tries to access remote jira instance and uses good credentials but the given user does not have access to the given jira project.
Also it helps to enable …
-
**What did you do?**
I got a lot of alerts, and then I find a batch of alerts resend all the time.
Finally I restart prometheus, and alerts stop sending
**What did you expect to see?**
These ale…
-
**What did you do?**
Set up two receivers to different Slack channels. The relevant config is as follows
```
route:
receiver: 'slack1'
group_by: ['cloud_service']
group_wait: 30s
…
-
What did you do?
Alert generated for an event(Label sets). Followed by this the event repeated a few times, However since prometheus generates the alert id based on the label sets it made a determina…
-
### What did you do?
I create a alert rule, but it generates alerts' project label is not `less`
```
(max_over_time(app:container:kube_pod_container_status_terminated_reason_error{namespace!~".*(…
-
**To Reproduce**
Steps to reproduce the behavior:
1. I'm running Harvester 1.3.0 on 2 management/worker nodes: T7920 and T7820i (Xeon 16 cores, 64GB+ RAM each). And I have witness node.
2. Cordone …