-
Hello,
I would like to ask for support within the rtl_433 project for Proteus Meter Ultrasound Oil device.
The product details can be found at the following link : https://proteus-meter.com/produkt…
-
Hi Marco,
I used your code for Battery Fuel gauge bq40z50 and EV2300 usb to analyze some of the parameters from the register,
however after running main.py I getting an error " No backend availab…
-
This is relating to the new battery percentage that was added in #63. I understand the battery calculation for Tempest is set with a maximum of 2.8V. However per Weatherflow, the ideal operating range…
-
Feature request: when the battery is low, an audible signal as well as the gauge would be helpful
-
I've recently installed Tow-Boot, as it has been my only solution to get working graphics on my already installed openSUSE. I installed oS via serial console, to the NVMe, LUKS encrypted,
With Tow-…
-
I am charging to 80% and because of the battery the voltage at 80% is shifting. It would be nice to use V as a limit and not percent. The gauge on the battery may not be accurate.
-
![image](https://user-images.githubusercontent.com/53581325/130344727-af6caed3-c12b-462f-80c4-ca879d125a20.png)
Normally that white line is supposed to be a temperature thing with snowflakes and stuf…
-
Hi
Is there a way to calibrate readings got clone chip that reads address as 0x76 but getting wrong readings.
Baterry is charged to 3.8v but reads as 2.2v and capacity is 0
Can you help here ple…
-
DUT9 is first proper prototype of Rev E.
There was a Rev E prototype that I did not end up assigning a DUT number due to its relative strangeness (It's the prototype on stilts -- frankly, I want th…
-
### The problem
I am unable to connect to my Netgear XR700 using Home Assistant. I'm a new user and have been unable to get passed the initial setup.
I'm currently running firmware XR700 V1.0.1.48
…