-
hi,
I have naze32 rev5 board with latest cleanflight, I mounted the board rotated 90deg with align yaw = 90)
when I open the sensor tab in gui and I roll the copter, in acc and mag display the Y-axi…
-
I'm thinking about adding MTK GPS. I have code mock-up in my fork
https://github.com/zdar/cleanflight/commit/99f65e883589b14be7ef50c7779f06cda5ea3671
It is completly untested now. Before I continue w…
-
Upgraded from D4R-ii to X4R and I do not see any RPM sensors available. Running OpenTX 2.1 on Taranis X9D Plus.
Also, tmp1 sensor shows erratic values using X4R. Normal temperatures when using CPPM/D…
-
I'm on Windows 8.1 and I'd like to experiment with embedded systems and contribute. Being an Eclipse newbie followed this guide:
https://github.com/cleanflight/cleanflight/blob/master/docs/development…
-
Hi,
today i tried RC2, however i am unable to arm, normally i arm with AUX1, after this didn't work, i tried to arm with the left stick (MODE 2). Doesn't work either.
Here is the dump of my settings…
-
I can play them with INAV blackbox explorer but with mwp (latest build for "ancient" ubuntu) no.
It says no log in the files.
[LOG00352.TXT](https://github.com/stronnag/mwptools/files/1033685/L…
-
If the Serial Receiver Provider section isn't applicable to those on RX_PPM, the interface could be cleaned up by disabling that section.
The Setup and Adjustment tabs currently do this with some ite…
-
Hello,
I-m working on uploading the firware using an ESP8266 over the USART1.
All sort of work, I can still get bidirectional communication over the USART1, but then i bridge BOOT and reboot the b…
-
Hello,
I was trying to do a PID tuning on my 450, with 800Kv motors running 10x4.5 props, Afro 20A ESCs with BlHelli OneShot setup, along with my Naze32 board today. When doing this I had what seeme…
-
The BOXLLIGHTS exists in the Cleanflight code, however doesn't seem to be used.
What about using this to switch one of the spare GPIO pins, like PA15 or PB5 on NAZE board?
The LLIGHTS stands of "land…