-
This is a separate ticket for discussing solutions for the filename extensions issue in the [Path to Raku PR](https://github.com/perl6/problem-solving/pull/89). I'm starting a separate ticket so that …
-
Buffer caps are currently 100nF, minimum recommended by datasheet is 400nF. We should use 1uF or 1uF+100nF.
-
My 12mm push button can't fit on top of `Button_Switch_THT:SW_PUSH-12mm` footprint.
The holes should be increased a litle bit.
It can be increased at least with the holes size used in `Button_S…
-
Sorry to post as a bug if I'm missing some step. Just reading the readme and installed the brew deps and then
./build.py --target package-kicad-nightly
I get:
> wxPython/Phoenix does not …
-
KiCad library usually have both the standard and the hand-soldering version of some footprints. I have been following the datasheet for the stardard footprint. But I do not know how much I need extrap…
-
I have seen a few footprints which has multiple lines in the same spots, probably because the were copied and paste and forgot about
-
## Issue description
KISYSMOD and KISYS3DMOD point to missing directories. On my system they are `/nix/store/dlx19m6rpfh79nqng9n7yxflr1vkqyn0-kicad-5.0.0/share/kicad/modules` and `/nix/store/dlx19m…
-
Dear all,
I think the footprint OptoDevice/ST_VL53L1X is rotated incorrectly by 180 degrees. The part was added in #1623.
Looking at the [datasheet](https://www.st.com/resource/en/datasheet/vl53l1…
-
Hello,
I think the footprint of 'Potentiometer_Omeg_PC16BU_Vertical' has a problem with the pad number.
In fact, the number 1 and 3 are interverted.
The Silkscreen is on the front layer, so the p…
-
The footprint Connector_Audio/Jack_3.5mm_Neutrik_NMJ6HCD2_Horizontal is misnamed. This is a 1/4" (6.35mm) jack, not a 3.5mm jack.
For reference: https://www.neutrik.com/en/product/nmj6hcd2
I ima…