-
Thank you for shared impressive project. I want to used wifi 2.4G/5G , the only esp32c5 compatible.So, I used the esp32-p4 chip for mcu host , and esp32c5 via sdio connected to esp32-p4 sdio port. How…
-
Hello, I am trying to use socketcan with your project for my research.
I have connected MCP2517FD to Raspberry PI 3B+ as follows:
GPIO9 -> MISO
GPIO10 -> MOSI
GPIO11 -> SCLK
GPIO8 -> CS
GPIO2…
ghost updated
4 years ago
-
Keep receiving a value of zero from analogRead. Moving this into its own issue from: https://github.com/nerdyscout/Arduino_MCP3x6x_Library/pull/5#issuecomment-1870591920
-
Using the example Klipper configs, as well as RRF, my SPIDER KING won't detect the BIG-5160 drivers I have installed in my board.
Klipper reports:
```
INFO:root:TMC stepper_x failed to init: Un…
-
-
### The problem
While trying to configure a SPI bus on an ESP32S2 using the Arduino framework the build fails due to VSPI not being defined for this platform. For ESP32S2 and ESP32S3 FSPI needs to be…
-
Hi,
I am not able to send or receive anything.
```
var rf24 = new nrf24.nRF24(19, 0);
rf24.begin();
rf24.config({
PALevel: nrf24.RF24_PA_MAX,
DataRate: nrf24.RF24_1…
-
First of all, thank you for this project. I assambled 2 boards flashing your firmware but I get errors writing to the SD (I have tried with various brands and partitions), reading is fine. Any ideas?
…
-
```pnpm run prepare``` to prepare all subgraphs
-
Hello, iam martin. I working with lora, old display and ethernet IoT and i have a question to that lib.
The lora shield and the display working **both with spi** and i want to try to work with two …