-
**What you are trying to do?**
Read a hall sensor using 3.3v / ground / IO2 pins after restarting the board programmatically.
**Describe your system( Hardware, computer, O/S, core version, envir…
-
My setup:
MKS Gen 1.4
Nextion 4.3 Enhanced
PID temp bed
Runout sensor set in the online configurator firmware but not connected (freeze the board)
No bed temp problem, runout sensor worked fine w…
-
My setup:
- Nextion 4.3 enhanced
- MKS Gen 1.4
- MK4duo 4.3.9 firmware
After starting the printer, Nextion displays "Printer ready" and the IP address when connected to the Raspberry (used only…
-
Thank you for the creating this.
I have been playing with my nextion for a long time but am not able to get it to work with any programming.
The only thing i do get is:
```
[14:26:02][W][nextion:0…
-
G'Day guys, i am a total noob when it come's to the technical side with PC's. Please see the log file i have copied and pasted below. I have been using SimHub faultlessly for over a year now for my …
-
### Issue description
On Board / LCD SD Card only read on system reset / restart. SD Card is detected (according to LCD) when inserted and removed, however M20 reports SD Init Fail. Again, when res…
-
As reported here: https://github.com/letscontrolit/ESPEasy/issues/1574#issuecomment-410065300
Suggested fix:
Make the callback function just register handling of the MQTT as a new job in the sched…
TD-er updated
4 years ago
-
Hello everyone!
I recently decided that I wanted to attempt to make a SimHub dash using the Arduino Micro with the W2128B LEDs and a display using the [Nextion Display](https://github.com/zegreatcl…
-
Hello everybody,
Today I wanted to test my Nextion Display and tested the "Dev" and "Test" versions.
The ESP8266 will work for a few minutes and then it will restart forever.
I also tested it wit…
-
Hello
The 4.3.9 firmware worked fine with my Nextion TFT4.3 and my MKS Gen 1.4 until I add the DHT sensor option to the online configurator and upload it to the board. When the board reboots the d…