-
### Basic Infos
#### Hardware
**WiFimanager Branch/Release:**
- [ X] Master
- [ ] Development
**Esp8266/Esp32:**
- [X ] ESP8266
- [ ] ESP32
**Hardware: ESP-12e, esp01, esp25**
- [ ] E…
-
Hello!
I do not know if it's proper place to ask, but I can't find answer myself.
When I do analogWrite() on pin 4 or 5 I'm getting disconnected from wifi.
in debug mode on serial monitor I'm get…
-
Noticed first that wifi functionality was unstable - worked for ~10 seconds and stopped. Traced it to a call of i2scBegin(); in setupEnd(); function. When call to i2scBegin(); is disabled in setupEnd(…
-
`Exception (9):
epc1=0x4020d008 epc2=0x00000000 epc3=0x402067a6 excvaddr=0x00000037 depc=0x00000000
>>>stack>>>
ctx: cont
sp: 3ffffc70 end: 3fffffc0 offset: 01a0
3ffffe10: 0000000b 3ffeeb00 …
-
Hi,
I just started my first tests using BrewPiLess with a NodeMcu. Thanks for a wonderful little design!
I use the FAN output configured on the D4 pin. It normally works as it should (or function …
-
Mark,
I am trying to use this code very simply with a nodemcu and a 4-relay board. I power the relay from a separate 5V line from the same usb power source. Have common grounds between them. Anywa…
-
Hi there,
I stumbled upon your git by searching for a way to control my Somfy awning. And yours looks to be the promising of all i found.
While waiting for my crystal to arrive I just can't figure…
-
Had some problems uploading so I want to share how i solved them.
In /cpm8266/code/Makefile there are the upload parameters. i've changed them to match the one used with Arduino IDE:
FLASHPARAM =…
-
Honzovy poznámky:
- [x] putty/picocom - vypnout HW flow control
- [x] ctrl-E dát do taháku ( pozn.: je to i v help() )
- [x] GPIO9 GPIO10 - připojeno k interní flash - nelze použít jako I/O
- [x] …
-
I have 2 milight controllers (fut036 with fut007 remote)
I find it very good remote (fut007), perfectly fits my needs (on/off, dim,spectrum change and 4 groups on/off). I have search for similar one …