-
Here's an excerpt on an off-line discussion about where Grbl is going and what's next:
**chamnit** : This is something I've been thinking about often recently. Is Grbl done? Or have we pushed it abou…
-
The Z-Up-Button jogs the Z-Axis down, Z-Down jogs it up.
Should be reversed.
Tested it with a tinyG as driver.
-
```
Views are different between the application and API. We need a way to make sure
all the features in the KML file are visible, and to center on them all or on a
single feature.
Requested by: Dou…
-
Firmware Version : 0.970
Firmware Build : 446.19
Hardware Platform : 1
Hardware Version : 8
ID : 3X3566-KBR
I ran into something on the latest Edge version. The satus reports seem to be stuck in filt…
-
Pretty sure it used to work, but it's been a while since I've used it.
-
```
Views are different between the application and API. We need a way to make sure
all the features in the KML file are visible, and to center on them all or on a
single feature.
Requested by: Dou…
-
I noticed that recently stepper units has been added to the G2.json config. I'm not sure why that was placed in there because as far as I know, it is not a G2 parameter, unless synthethos hasn't updat…
-
I have been fighting a problem for quite some time and have tracked it down to the queue report and
status reports not working the same in all situations.
I like to step through my GCode programs, me…
-
Installing this library on both my mac (with node 4.1.1) and raspberry pi (with node 4.2.1) yeilds almost the same message. Is there a trick to getting this installed? Looks like a nice lib!
## pi@r…
-
Hi, I've just downloaded the 64bit version and it auto updated, but in the preferences the only target board is Grbl, how do I tell it to use the TinyG controller?
Cheers,
Stephen.