-
I have been using 6lbr for couple months without any problem, but somehow it stopped routing udp packets to the sensor network (aaaa::/64) . I am able to receive UDP packets from the contiki nodes.
I…
-
Hi,
I have a problem to configure the Border router on an IPv4 network with an IPv6 tunnel.
I already tried the client exemple and its working with the Firefly border-router on an **IPV6 network**…
ghost updated
7 years ago
-
Re-plug in the Ethernet socket, the recovery and reestablishment of the IP communication is not working anymore after the move to sal-stack-nano 5.x.x. The Ethernet driver reports the up state, but no…
-
I am spent two weeks without having made any progress in trying to figure out in which modes I must configure 6LBR to connect with the TI's sensortags to try out how easy/complex it is to setup contik…
-
About week ago I succeed with building my first 6lowPAN sensor network. The setup is following: 6lbr, running under Ubuntu VM with cc1310 slip-radio connected to it. Output from slip-radio is followin…
-
This issue lists the status of all tests for the [Release Candidate 1 of the 2017.04](https://github.com/RIOT-OS/RIOT/releases/tag/2017.04-RC1) release.
Specs tested:
- [ ] [01-CI](https://github.…
-
how to enable all the debug in libcoap. Tried with -V option but never seen any messages.
-
Hello there,
If I use 6lbr as the border router and run cetic-6lbr-client.c on my 6lowpan nodes along side of my application code which just opens up some UDP sockets and transmits periodic data, i…
-
Hi,
I have been working for some time now with 6lbr. My setup is basically a RPI2 which acts as a border router and in which 6lbr is deployed. The RPI2 has connected to one of its USB ports a CC265…
-
Target: NCS36510
Toolchain: Any
Error:
Stack overflow. Adjusting the stack and heap sizes prints out varying debug messages but regardless of what size they get set to, it will always fail
Attem…