-
Running artiq 3.6 with a KC705 at NIST, we get errors every ~10-20 minutes where communication between core device and PC fails and the current kernel is ejected. Usually the next experiment submitte…
-
To try to pin this down further, looked on a scope during the init.
With the new init sequence, I no longer see any broad band noise but, as expected, the HMC7043 turns on briefly at the wrong freq…
-
I visited quantum physics lab in Torun (Poland). Guys make ion-trap experiments where they additionally treat Ca ions with electron beam.
They are interested in Sinara/Artiq ecosystem, and would lik…
-
Hello everyone,
as a student of @gkasprow I have made firmware for thermostat's TM4C chip and I want to receive a feedback from you. Source files are in firmware branch. I will try to describe feat…
-
- [x] DNP JESD204 ADC on Sayma RTM, as well as all associated components (regulators etc). Do not remove from schematic/PCB, so that users can populate them if they desire.
- [x] If easily possible, …
-
Test setup:
- using ADF4356 eval board
- clock applied single-ended to REFINA SMA at +6dBm
- cut traces to disconnect on board XO from PLL ref in
- remove R7 to power down XO
- replace R6…
-
The PB3 SW is routed to the MMC (LPC1776). Currently @gkasprow reports that it does nothing. What should its default behavior be? @sbourdeauducq
1) MMC: reset, reconfigure from flash
2) AMC FPGA: r…
-
```
sawg.frequency0.set(1000*MHz)
```
Produces no error though the frequency is out of bounds. And the output is nonsense.... time-varying amplitude fixed frequency.
-
```python
from artiq.language import *
class Hammertime(EnvExperiment):
def build(self):
self.setattr_device("core")
self.setattr_device("ttl4") # on master
self…
-
Comments of @gkasprow front panel designs. They look good!
- [x] Please use EEM code names where possible. Let's keep the amount of text on the front panel to a minimum so it doesn't get over crowd…