-
My board surport float point number transmission. When excute" data = master.execute(address, cst.READ_HOLDING_REGISTERS, regAddress, quantity, data_format='f')", "modbus_tk.exceptions.ModbusInvalidR…
-
Title - Is the System polling the Modbus Slave?
- QUESTIONS - How does one figure out if the Arduino is polling the slave device. In my case this is the Delta PID controller with ID - 1
Provide…
-
Hi,
I'm trying to tun a NModBus on a Raspberry Pi using UWP.
I can comunícate with ModBus modules but during the programm running in the Output windows (Visual Studio) appear every time that I r…
BullT updated
3 years ago
-
Hi,
I dont know if this is a yosemite issue or more with esp8266.
I have a older wemos v3 esp8266 and this library together with sensorModMaster does not work with newer versions than 2.5.2.
Accord…
-
Only low baudrate allowed, maximum is 115200 for now.
But why? USB-Serial adapters allow much higher baud rates.
May be allowing any baudrate (may be with some special key) will be possible?
…
-
```
I am using a Trio Motion controller, connected via USB for programing and
with serial / Modbus for data transfer to run a custom application.
What steps will reproduce the problem?
1. try to wr…
-
```
I am using a Trio Motion controller, connected via USB for programing and
with serial / Modbus for data transfer to run a custom application.
What steps will reproduce the problem?
1. try to wr…
-
```
I am using a Trio Motion controller, connected via USB for programing and
with serial / Modbus for data transfer to run a custom application.
What steps will reproduce the problem?
1. try to wr…
-
```
I am using a Trio Motion controller, connected via USB for programing and
with serial / Modbus for data transfer to run a custom application.
What steps will reproduce the problem?
1. try to wr…
-
Can an example program for Modbus TCP ---> Modbus ASCII be added?