-
```
What steps will reproduce the problem?
1.
2.
3.
What is the expected output? What do you see instead?
Should allow the sketch to define pins used to communicate with SoftwareSerial
library.
Mus…
-
```
What steps will reproduce the problem?
I'm using a SIM900 on a Seeedstudio Modem.
To send data via CIPSEND, a ctrl+z is needed finally.
NOT working: gsm.SimpleWriteln((char)26);
Working: Ser…
-
```
1. On Arduino 1.0.4, open the Library_Client example the is distributed with
the package.
2. Configure the service provider GPRS details.
3. Upload the sketch to Arduino Duemilanove and watch the…
-
```
What steps will reproduce the problem?
1. plug in ext psu
2. download gprslibrary_sms example
3. run serial monitor
What is the expected output? What do you see instead?
expect to see sms sent
…
-
```
What steps will reproduce the problem?
GSM Shield testing.
DB:NO RESP
DB:NO RESP
DB:NO RESP
ERROR: SIM900 doesn't answer. Check power and serial pins in GSM.cpp
status=IDLE
use: GSM_Shield_GPRS…
-
```
What steps will reproduce the problem?
1. Download version 1.0 of Arduino IDE
2. Download version r47 (HEAD at this time) of the 1.0 compatible branch
(http://gsm-shield-arduino.googlecode.com/sv…
-
```
I'm using Arduino Mega 2560 with IComSat GSM shield.
I've already trim the pins 1 and 2 of the shield(the ones below arduino's pin 1
and 0) so I must use these ones :p
The codes of the library on…
-
```
What steps will reproduce the problem?
1. Upload GSM_GPRSLibrary_SMS.ino and change the phone number together with the
country code
2. Change the TxRx pins on my shield to pin 2&3 which stated in…
-
```
Hello guys.
I've been working on an interfacing system of GSM Shield SM5100-B with Arduino
UNO Rev 3. and a keypad and an LCD.
when I used the example to send an SMS from the Arduino staticall…
-
```
What steps will reproduce the problem?
I am using iteadstudio GBOARd with SIMCOM900 and SD.
http://iteadstudio.com/store/index.php?main_page=product_info&products_id=537
Arduino Ide 1.0.1
Simcom …