-
### Description
Trying to test TMC2208 with DUE and I'm getting TMC Connection Error.
The TMC2208 drivers are good for sure as they work standalone, and I can connect to them via serial using a f…
ghost updated
4 years ago
-
###Printer
Ender 3 with SKR V1.3, TMC2208 on XYZE in UART mode, stock CR10 Display
### Description
When you turn on the printer with a firmware compiled after commit 48d1bd29c causes the foll…
-
### Bug Description
When printer is turned on via M80 command from any source, my TMC2208 driver settings keeps changing.
### My Configurations
Bigtreetech SKR v1.3, Octoprint on Raspbe…
-
### Description
PSU power cycle clears TMC2208 settings
### Steps to Reproduce
1. Power off board and machine
2. Power on both
3. Send `M122`
4. msteps are set to 8 ( print head will happi…
-
### Bug Description
Based on Marlin 2.0.7.2.
Extruders are weak an can't push filament through. Problem is caused by failing to set the digipot values for the stepper drivers due to the fact tha…
-
I've a gt2560 rev3.
ive mount 2 stepper driver ,but i cant dialogue with motherboard,but can with an external uart/usb module.
If its fully supported,can i do a comunication with both?Or i need 4 …
-
### Bug Description
hard knocking on travelmoves - each one time while accelerating/decelerating across hybrid_threshold.
travelmove speed is 200mm/s, acceleration 1200, hybrid_thershold teste…
-
вот пример
https://www.youtube.com/watch?v=sSO3Xd0a0Z8
но были какие-то проблемы с ними на экструдере и/или с включенным linearadvance
-
While printing with TMC2208 i hear a crack while it's printing the first layer and suddenly it's printing twice the size, .. again turn of the printer restart everything, and suddenly everything goes …
Ofloo updated
4 years ago
-
Hi
I have an SKR 1.4 Turbo. I've installed TMC2208 driver (UART mode) in X, Y, Z axis (this works) and i have tested A4988 (motor is stuttlering and dont change direction), DRV8825 driver (motor do…