-
-
The first time I uploaded a simulation background image, it has been displayed, but was extremely zoomed in. Therefore I tried to zoom out with the mouse wheel (rolling it back). This lead to Firefox …
-
I'm having a huge problem with the library using the Arduino GIGA R1 WiFi.
I have a system made up of GPS, IMU and SD card and I would like to connect to a peripheral.
if I load the example progra…
-
Dear Carla community,
i would like to know whether Carla has a Optix development toolkit to implement a customized lidar, radar and ultrasonic sensors or not?
Could i implement my sensors e.g. Li…
-
# Background
I have taken the LoRaWAN example and managed to connect to TTN.
I have set up two devices in TTN to test this issue for APB mode and OTAA mode respectively.
Using the LoRaWAN MAC…
-
### GHEPI use case - Injection moulding sector
The goal is to demonstrate that an effective solution of human-machine mutualism and dynamic intrinsic job rotation through easy uptake of an AI-based k…
-
Hello there,
I just purchased RPi3 a week before and trying to connect GSM SIM 800 module using serial ports (pin 8, 10).
Initially I am trying check serial ports by connecting pin 8-10 and using min…
-
Hi!
I am using the JSN-SR04T with tasmota succesfully.
When I setup the device (a few months back) I think i changed the output of the sensor to show only 1 decimal. I now need the sensor to out…
-
To fix the overheating issue, we used 4 separate cables and didn't join them into one wire as that was too much power and melted the plastic connectors. This reduced the power draw for each plug to 1/…
-
Hello,
i have a Wemos D1 Mini ESP8266, with a HC-SR04+ Ultrasonic Modul (3,3V Version)
The ESP8266 works with a solar powered 3,7V Batterie and works almost fine.
Deepsleep is activated (900sec S…