-
The following commands are needed to allow traffic when firewalld is being used.
````
sudo firewall-cmd --add-service=dhcp
sudo firewall-cmd --add-service=dns
sudo firewall-cmd --add-masquerade
…
-
Hi,
I have some devices that loses connection due to power management or bad signal quality, and then reconnect almost immediately. Another reason is disconnecting from current AP and then connecti…
-
Hello.
I have the following setup in an automation environment
Raspberry Pi 3B running Raspbian with Mosquitto MQTT broker and Node-red. This is the master hub controller (connected via ethernet ca…
-
**AndroidManifest.xml**
All activities & services are declared here. It tells you what screen shows up first, what screens exist, what orientations are supported and so on.
**transmission/Receiver…
-
I am using an ESP32 Andy have it all setup and it seems to work for 24-48hrs but then alexa reports device not responding check its network/power supply connections.
If I reset it it does the same ag…
-
### Subject of the issue
I am running a SparkFun Lightning Detector - AS393527 SEN-15441, connected to a SparkFun Thing Plus - ESP32 WROOM (USB-C) WRL-20168. All activity on the SPI bus (VSPI or HSPI…
-
Just set up a reader for a Aidon 6534 with a RJ12 connector, which seems to be tested before.
Getting messages of discarded reading.
Tried the same reader at home on a Sagemcom yesterday and that wo…
-
### Describe the bug
I keep getting disconnects and 10 minute uploads when streaming. Running latest updated today.
Any ideas on what to try?
down
[WyzeBridge] ✅ '/cat-cam stream is UP! (3/…
-
Was using wifi, plugged in ethernet, reboot Retropie.
When I started a rom (and exited) same error message, Not Connected to Internet.
Problem went away when I did that. (I saw this somewhe…
-
I am trying to get this working and I get:
Send USER
Send PASSWORD
Send SYST
Send Type A
Send PASV
Guru Meditation Error: Core 1 panic'ed (LoadProhibited). Exception was unhandled.
Core 1 re…