-
- [x] For unused PEX pins, put a current limiting resistor (e.g. 100 ohms) to ground
- Only do this if you're tying it to ground, otherwise can leave floating
- [x] Fix ADC (ADS7952) circuit - op …
-
```
Steps to reproduce the problem
1. Connect MinimOSD to the APM in parallel to the Xbee or any other modem,
following the instructions of the tutorial. Remember to do not connect the APM
RX pin w…
-
I have this wheel and would like to use it on my Playstation 2 and 3 (with ps2 emulation)
There is no force feedback so no motor control needed. Just the spring, axis and buttons.
-
### What happened
Used configurator to setup Vcore 3.1 with SKR Pro 1.2, RatOS.cfg sets some wrong pins for the board which leads to Klipper not starting. Also in the wizard, setting- Electronics -…
-
Hi there, running into an issue and do not know where to really begin to debug it.
In file included from sketch\Settings.h:53:0,
from C:\Users\nogardvfx\Downloads\printer-monitor-…
-
Allow precompiled headers to be used when compiling C++, to make the build faster.
-
So far Results are a backend-specific interface of a key-value store where values are blobs of texts.
I'll elaborate a bit more later but I would like to:
- a) have the type checker avoid spelling mi…
-
Hello phdlee,
I discovered your firmware here on github almost by chance. since I have a k5 dedicated to testing and a si4732 in the drawer, I'll try to put it in place of the original chip! I just h…
-
@lshachar
Hi Ishachar, I used the connection schema (the good one, not mine)
I soldered all wires correctly to the Level Shifter and to the pins. I uploaded the sketch arduino_fanatec_wheel.ino p…
-
I suspect that `g::Graph` in this function https://github.com/AlgebraicJulia/Catlab.jl/blob/main/src/graphs/GraphAlgorithms.jl#L122 should actually be `g::HasGraph`?