-
Discovered in #2061
When using DEFMT + RTT + probe-rs the exception handler isn't able to produce any output. I get a message like `WARN probe_rs::util::rtt::client: RTT control block corrupted (…
-
When it's safe to use, 0-RTT can significantly reduce the TTFB. Measuring savings can help inform the cost-effectiveness of implementing safeguards against replay attacks and adopting 0-RTT; this tool…
-
#### Problem
The QUIC server doesn't not accept client connections with 0-RTT. Is that a wanted behaviour ?
The rust-ls server config parameter `max_early_data_size` must be set to `u32::MAX` so t…
-
I want to test the 0-RTT capabilities of the client but in my traffic captures I never see any 0-RTT packets sent out from the client.
My server is a very basic caddy file server and reverse-proxy se…
-
can server/client save the cfg/session file to use 0-rtt ?
-
Ever consider replacing `quic.Listen()` with `quic.ListenEarly()` to make use of 0 RTT of quic?
I believe it will reduce 1 round trip time (around 200ms) when resuming a connection.
What do you …
-
سلام. وقت بخیر
امروز یه چیزی رو متوجه شدم. من کانفیگی که به کاربر دادم فقط روی پورت 80 هست ولی وقتی دستور journalctl -u tunnel.service -f میزنم در سرور داخل غیر از کانکشن به پورت 80 ، به پورت های دیگ…
-
Note in the draft that raw QUIC can to 0-RTT moq setup but webtransport does not support this. Add text to security section of why this is safe.
-
There is a small risk that the probe will inspect RAM whilst we are in the middle of copying from Flash to RAM, and it might see the SEGGER RTT header but then see invalid pointers.
So we should in…
-
Here is an example of invalid IPs for gRPC traffic
`ipv4: 13:59:40.537606 eth0 IP 128.120.33.77:32888 > 138.28.0.0:8525: dscp: 0x14 protocol:tcp type: 0 code: 0 dir:0 bytes:32 packets:1 flags:16 en…